Technicqll instant adhesive with brush 8g

This Technicqll instant adhesive with brush is a colourless cyanoacrylate adhesive for metals, aluminium, glass, rubber and other elastomers, plastics (PVC, ABS; not PP, PE or PTFE), wood, ceramics, leather, cork, stone, paper and cardboard. The brush in the cap helps you apply it to large surfaces and hard-to-reach spots.

Use it to repair jewellery and ornaments, appliance housings, toys, plastic phone flaps, porcelain figures, laptop housings and small parts of musical instruments, and to bond models and O-rings.

Technical data

• Base: cyanoacrylate
• Colour: colourless
• Viscosity: 80-100 cP
• Max. gap fill: 0.10 mm
• Initial setting time: 2-10 seconds, depending on the material
• Temperature resistance: -55 °C to +80 °C
• Storage temperature: +5 °C to +20 °C
• Content: 8 g

How to use

• The surfaces must be clean and dry.
• Bond at room temperature and 50-60% relative humidity.
• Apply the adhesive to one surface. Do not use too much: the thinner the layer, the stronger the bond.
• Join the surfaces at once, check that they are aligned and press them so the adhesive spreads evenly over the whole bonded area. Hold the parts still for a dozen seconds or so, and do not move or realign them.
• Wipe off excess adhesive right after bonding. Technicqll instant adhesive remover P-093 also removes adhesive residue.
• Too much humidity or too thick a layer can leave a white bloom on the bonded surfaces.
• For PP, PE and PTFE, use an instant adhesive with primer: the PP and PE adhesive X935 or the PP and PE gel C-086.
• In dry air or at low temperature, use the instant adhesive with activator X-942.

Warning

• Cyanoacrylate. Danger. Bonds skin and eyes in seconds.
• Contains hydroquinone. May produce an allergic reaction.
• Causes skin irritation.
• May cause an allergic skin reaction.
• Causes serious eye irritation.
• May cause respiratory irritation.
• Keep out of reach of children.
• Wear protective gloves, protective clothing, eye protection and face protection.
• IF ON SKIN: wash with plenty of soap and water.
• IF IN EYES: rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• If eye irritation persists: get medical advice.
• If skin irritation occurs: get medical advice.
• Dispose of the contents and container in accordance with applicable waste regulations.