Technicqll instant adhesive gel for vertical surfaces 2g

CIA - Gel is a one-component, colourless Technicqll instant adhesive in gel form, based on ethyl cyanoacrylate. It cures by moisture. The thixotropic gel does not run off vertical surfaces and is not absorbed by porous ones, so it suits vertical surfaces and porous materials.

It bonds metals, aluminium, glass, rubber and other elastomers, plastics (PVC, ABS; not PP, PE or PTFE), wood, ceramics, leather, cork, stone, paper and cardboard. Use it to fix decorative trim strips and to repair cracked lamp shades, jewellery, appliance housings, toys, plastic phone flaps, porcelain figures and laptop housings.

Technical data

• Base: ethyl cyanoacrylate
• Colour: colourless
• Viscosity: gel
• Max. gap fill: 0.25 mm
• Initial setting time: 18-60 seconds, depending on the material
• Temperature resistance: -55 °C to +80 °C
• Storage temperature: +5 °C to +25 °C
• Content: 2 g

How to use

• The parts must be dry, clean and free of grease.
• Bond at room temperature and 50-60% relative humidity.
• When you first open the tube, pierce its membrane with the top of the cap.
• Apply the adhesive sparingly to one surface; one drop is usually enough.
• Put the parts together quickly and check that they are aligned. Press so the adhesive layer is as thin as possible, and hold them still for a dozen seconds or so.
• Do not move or realign the parts until the adhesive has set, which usually takes a few seconds.
• Remove excess adhesive with Technicqll instant adhesive remover P-093.
• For PP, PE and PTFE, use the Technicqll adhesive for hard-to-bond plastics.
• In dry air or at low temperature, use the Technicqll instant adhesive with activator.

Warning

• Cyanoacrylate. Danger. Bonds skin and eyes in seconds.
• Contains ethyl 2-cyanoacrylate.
• Causes skin irritation.
• Causes serious eye irritation.
• May cause respiratory irritation.
• Keep out of reach of children.
• Use only outdoors or in a well-ventilated area.
• Wear protective gloves, protective clothing, eye protection and face protection.
• IF ON SKIN: wash with plenty of soap and water.
• IF IN EYES: rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• Dispose of the contents and container in accordance with applicable waste regulations.