Technicqll enamel repair kit in a syringe 6ml

Technicqll liquid epoxy enamel is an epoxy-resin based liquid ceramic in a syringe for repairing cracks, scratches and other defects on white enamel, ceramic, acrylic and lacquered surfaces. The two components are mixed 1:1. The enamel adheres to all materials except polyethylene and polypropylene, resists cleaning agents and detergents, and can be sanded once it has cured.

The kit holds the syringe of enamel, a protective sticker and polyethylene film. Cured enamel can only be removed mechanically.

Uses

• Sanitary ware: baths, washbasins, urinals, shower trays, cisterns and sinks
• Washing machines, refrigerators and gas cookers
• Filling defects in lacquered furniture and in tiles

Do not use

• For repairing enamelled pots
• For bonding or filling PP, PE and PTFE

How to use

• Clean the area of rust and loose old coating, degrease it and let it dry.
• Break the tip off the syringe nozzle and remove the guard between the plungers. Squeeze a little enamel onto a sheet of paper to push out air bubbles.
• Cut a hole the size of the repair in the white protective sticker and stick it onto the surface.
• Squeeze out the amount you need and mix the components thoroughly with a spoon for at least 2 minutes.
• Apply the mix to the repair, spread it evenly and take off the excess so the surface stays level.
• Once the mix is applied, remove the protective sticker.
• For a smooth, glossy surface, lay the polyethylene film on the uncured enamel and smooth it gently. Remove the film once the enamel has fully cured.
• Fill scratches and small cracks with a sharp stick, such as a toothpick.
• On vertical surfaces apply the enamel in thin layers so it does not run. Apply the next layer once the previous one has cured, at intervals of about 3 hours.
• Wash the repaired item with detergents no earlier than 7 days after the repair.

Technical data

• Base: epoxy resin
• Mixing ratio: 1:1
• Colour: white
• Pot life after mixing: 30 min
• Initial cure: 5 h
• Full cure: 24 h
• Temperature resistance: -40°C to +80°C
• Application temperature: above +10°C
• Volume: 6 ml

Warning

• Harmful if swallowed.
• Causes severe skin burns and eye damage.
• Causes skin irritation.
• May cause an allergic skin reaction.
• Causes serious eye irritation.
• Toxic to aquatic life with long-lasting effects.
• Harmful to aquatic life with long-lasting effects.
• Contains epoxy constituents. May produce an allergic reaction.
• Keep out of the reach of children.
• Do not get in eyes, on skin or on clothing.
• Avoid release to the environment.
• IF IN EYES: rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• Dispose of the contents and container in line with the waste regulations in force.